The Specification of the Storage and the Assembly for the Membrane Keypad Switches

Membrane keypad switches are electronic accessories. Many times when customers assemble membrane keypad switches, they will always be scrapped due to storage and placement problems. Knowing how to assemble is a very important course, so Nice one-tech is very Wanted to introduce the placement and storage methods to customers.

How to assemble and store membrane keypad switches?

1. There is not allow hard scratch and impact at the front side, and each layer can't be pulled apart. If not, it will destroy the construction of the membrane panels and will affect the lifetime of the products.

2. Clean the enclosure where need to assemble the membrane switches, and the enclosure surface should be flat, without rust, without oil, and without dust.

3. Check the position and the direction of the enclosure and tear off the bottom liner of the membrane switches. If the fingers can't touch the bottom adhesive, then assemble the switches to the correct position.

4. When you assemble membrane switches with the adhesive and already tear off the bottom liner but without the assemble, the membrane switches need to be side up and be sure the others can't touch the rear adhesive. Also, the membrane switches are already torn off the bottom liner and can't be on hold for a very long time, or this will affect the adhesive function.

5. When assembling the switches, you need to finish the assembly at one time. When you assemble the membrane switch, you couldn't touch the membrane buttons, and the membrane switches couldn't bend and can't reuse it. If not, it's easy to destroy the switches and also will affect the function of the adhesive.

6. The tail cables of the custom membrane keyboard can be bent, but can't be deadened. It is easy to cause the open circuit、 a bigger resistance, then affect its function.

7. The membrane switches need to be stored at the normal temperature, dustproof, and waterproof, and be sure there are no acid gases, no alkaline gases, and no other's corrosive gases.

8. When testing the membrane switch keypad, need to be sure the test table is hard and steady, can't press the keys dangling. When storing the rubber membrane switch, but sure the products are without the extra press or bend.

If you want to know more, please contact info@niceone-tech.com.